Philips Magnavox - Advanced Convergence Menu

www.TvRepairKits.com

Convergence Touch Up Procedure

1. Enter the convergence service mode (06-25-97-Menu).

2. Select the color which requires adjustment.

Note: Do not select green geometry (1). This procedure is described under the "Major

Convergence/Geometry Alignment Procedure." If green geometry is altered during this procedure, it

may become necessary to perform the Major Convergence/Geometry Alignment.

3. Cover the output lens of the single color presently not being adjusted (e.g., if you select green to red (4),

cover the blue output lens).

4. The highlighted adjustment icon (cross) should be illuminated on the middle left side of the screen. Make

the necessary convergence adjustments using the following remote control transmitter keys:

Use the cursor up key () to adjust the selected color up.

Use the cursor down key () to adjust the selected color down.

Use the cursor right key () to adjust the selected color to the right.

Use the cursor left key () to adjust the selected color to the left.

5. Move to the next location to be converged. It is not required that the full convergence sequence be

followed while performing the Convergence Touch Up Alignment Procedure. The following alternate

remote control transmitter keys allow for positioning of the icon to the desired adjustment location:

Key 2 on the remote control transmitter moves the adjustment icon upward.

Key 8 on the remote control transmitter moves the adjustment icon downward.

Key 4 on the remote control transmitter moves the adjustment icon to the left.

Key 6 on the remote control transmitter moves the adjustment icon to the right.

6. Return to the convergence service menu by pressing key number 3 on the remote control transmitter or

by sequencing the icon to the last adjustment point at the lower right corner of the screen and pressing

the Menu (M) key on the remote control transmitter.

7. Repeat steps one through six for other required convergence alignments.

8. To save the new adjustment settings, exit/save the convergence service mode by pressing key number 1

on the remote control transmitter. This writes the corrections to the EEPROM on the Convergence

Module.

Note: To save the convergence corrections made above, you must exit the convergence menu by selecting

Exit/Save Data (1)